K-COM Model RF-1 Coiled Cord Filter
 Radio Frequency Interference can
enter a telephone set (or telephone system) through often overlooked points. One of these
is the coiled cord between the base of a telphone and the handset. If intensity of the
interference varies as you move the coiled cord, it is likely that the cord is acting as
an antenna. The RF-1 Coiled Cord Filter gives you a convenient, low profile method of
plugging-in interference rejection right where it is needed. When the handset contains
electronics such as microprocessor, keypad, audio amplifier, etc., insert filter at the
handset. When electronics are in the base, locate the filter at the base.
| - |
Simple, plug-in installation. |
| - |
Mini-modular connectors. |
| - |
Lightweight, low-profile impact-resistant plastic case. |
| - |
Engineered stress-relief line cord. |
| - |
Transparant to telephone signals. |
| - |
Multiple filters can be used on affected equipment. |
| - |
Choice of optimized performance ranges: 0.5 - 3.0MHz / 3.0 - 30MHz / 26 - 60 MHz /
100MHz |
| - |
Made in U.S.A. |
|
 |
 |
This product is Classified to U.S. and Canadian safety
standards by Underwriters Laboratories Inc. Communciation Circuit Accessory 9P69. |
K-COM Filter Applications
K-COM Filter Applications for Coiled Cords
Frequency Range Descriptions
|
